Firmware
How do I update my firmware to be compatible with the RTD Pt100?
The RTD Pt100 works with Marlin, Duet/RepRapFirmware (RRF), and Klipper but requires a MAX31865 amplifier. Many boards have an expansion board for the amplifier like a daughter board by Duet3D. Marlin When compiling Marlin, choose temperature sensor ...
Updating my Prusa firmware for the Slice Engineering RTD Pt1000
Follow these steps to upgrade the firmware for your Prusa printer for a Slice Engineering RTD Pt1000. This will apply when you plug your RTD PT1000 into a thermistor port with no amplifier board Part 1: Download Prusa Firmware 1. Download Arduino IDE ...
Adding Temperature Sensor Redundancy to Klipper
The Mosquito® Magnum+ hotend boasts the ability to use multiple temperature sensors for redundancy, which can also serve as a safety feature. In Klipper, the method to add in this feature requires a workaround that is simple to implement. Do not ...
I just updated my firmware and my printer seems to freeze when it auto-levels. How should I fix this?
If you find that your printer is freezing when you are trying to auto-level, this could be an SD card issue. Make sure your SD card is formatted properly to work with your printer. Some printers have screens/hardware that only work with SD cards ...
How do I update my firmware to be compatible with the RTD Pt1000?
The RTD Pt1000 works natively with Marlin, Duet/RepRapFirmware (RRF), and Klipper. Marlin When compiling Marlin, choose temperature sensor #1047 if you are not using a MAX31865 amplifier. If you want to print above 300°C, you will need to raise the ...
Mosquito Magnum+® Dual Heater Configuration for RepRapFirmware 3.0+
The first method of configuring a dual heater Mosquito Magnum+® is using a single logical heater with two physical outputs. The second method involves using two heaters in parallel, acting as a single heater with double the power. The third ...
During setup with my Duet printer, I'm getting a "A heater fault has occurred" error when trying to heat.
Your thermistor resistance/temperature values in the printer's firmware likely needs to be updated. Go to the RepRapFirmware Configuration Tool and follow the prompts until you get to "Heater configuration". Select the EO or E1 sensor channel, ...
How do I update my firmware to be compatible with the Slice Engineering Thermistor?
300°C Thermistor The 300°C Thermistor works natively with Marlin, Duet/RepRapFirmware, and Klipper. Marlin If you are compiling Marlin for use with the 300 °C Thermistor, make sure to choose the "100K thermistor - ATC Semitec 104NT-4-R025H42G". This ...
After upgrading to a Mosquito™ Hotend, are there any firmware tweaks needed?
We recommend performing a PID tune after making any changes to the hotend setup on your 3D printer, including changing sensors, heaters, hotends, or adding thermal paste. If you are also upgrading to our Thermistor, you will need to update the ...
How do I address a firmware "mintemp" error?
If your firmware is Marlin, please set the mintemp value in your firmware to the recommended value from Marlin (5°C). If your firmware isn't Marlin, please contact your 3D printer's manufacturer.