I just updated my firmware and my printer seems to freeze when it auto-levels. How should I fix this?

• Related Articles

• How do I address a firmware "mintemp" error?

  If your firmware is Marlin, please set the mintemp value in your firmware to the recommended value from Marlin (5°C). If your firmware isn't Marlin, please contact your 3D printer's manufacturer.

• During setup with my Duet printer, I'm getting a "A heater fault has occurred" error when trying to heat.

  Your thermistor resistance/temperature values in the printer's firmware likely needs to be updated. Go to the RepRapFirmware Configuration Tool and follow the prompts until you get to "Heater configuration". Select the EO or E1 sensor channel, ...

• How do I update my firmware to be compatible with the Slice Engineering Thermistor?

  300°C Thermistor The 300°C Thermistor works natively with Marlin, Duet/RepRapFirmware, and Klipper. Marlin If you are compiling Marlin for use with the 300 °C Thermistor, make sure to choose the "100K thermistor - ATC Semitec 104NT-4-R025H42G". This ...

• Where's my printer?

  We are sorry that your printer is unavailable on our Shop by Printer page. We only have a certain amount of printers available on site for personal testing, and without testing and development, we cannot offer plug-and-play parts for your printer. We ...

• Updating my Prusa firmware for the Slice Engineering RTD Pt1000

  Follow these steps to upgrade the firmware for your Prusa printer for a Slice Engineering RTD Pt1000. This will apply when you plug your RTD PT1000 into a thermistor port with no amplifier board Part 1: Download Prusa Firmware 1. Download Arduino IDE ...