Desiccant Activation Testing White Paper
Filament Drying Desiccant Usage Instructions
Gather the materials you will need: the Filament Drying Desiccant canister a spool of filament that needs to be dried (spoiler alert, all spools need to be dried! Even many of the ones you just took out of the packaging) a storage container of some ...
I would like to replicate your volumetric flow rate tests. Can I have the model used for testing?
Yes, you can! The specific flow rate test model used is dependent on the diameter of the nozzle orifice. Each test uses an extrusion width equal to 150% of the nozzle orifice and a layer height equal to 80% of the nozzle orifice. While the height of ...
I'm experiencing stringing with my Mosquito™, Mosquito™ Magnum or Copperhead™ Hotend. What should I do?
There are multiple things that could cause excessive stringing. Several things to check first are: 1. Is your filament dry? Many filaments are highly hygroscopic, meaning they absorb water from the surrounding air. Filament should always be stored in ...
Where's my printer?
We are sorry we don't have your printer available on our Shop by Printer page. We only have a certain amount of printers available on site for personal testing, and without testing and development, we cannot offer plug-and-play parts for your ...
Adding Temperature Sensor Redundancy to Klipper
The Mosquito® Magnum+ hotend boasts the ability to use multiple temperature sensors for redundancy, which can also serve as a safety feature. In Klipper, the method to add in this feature requires a workaround that is simple to implement. Do not ...