Poor heating performance with Mosquito Magnum
I recently contacted support about this issue, but the responses are taking days, and I am getting very frustrated with this issue. Below is my original message to the support team. "I am running Klipper on a BTT SKR1.4 Turbo, and I am unable to get my
Upgraded from Mosquito to Mosquito Magnum, now it overheats
I upgraded my Prusa's Mosquito to a Mosquito Magnum, including the insulator. I used the boron paste on everything, redid PID autotuning, and did a few prints, everything looked good. But eventually it jammed up. I checked the Bondtech extruder tension;
Stringing with Prusa Mini w/ BondTech extruder and Copperhead hot end
I went all in with the upgrades for my Mini. I can print filaments now that I couldn't print before. The print quality is over the top. Mini has never printed this well before. However... I have bad stringing that that won't go away. The stringing is